AGCO Glencoe CC4450, Руководство оператора

Страница: 11 / 37

OPERATION
TRACTOR PREPARATION
General
· Check fluid level in the tractor hydraulic system
reservoir. Additional fluid may be required after
charging the chisel plow hydraulic circuits.
· Add front frame and wheel weights as needed
to maintain stability on hillsides and when
transporting the implement.
· Inflate and ballast the tractor tires according to
the tractor operator’s manual.
· Use a tractor with adequate horsepower. See
SPECIFICATIONS Section.
Drawbar
· If tractor is equipped with a swinging drawbar,
lock drawbar in center position.
· Adjust tractor drawbar height to approximately
17" (45 cm) above ground, as measured from
top of drawbar.
CHISEL PLOW PREPARATION
General
· Perform “Beginning of Day” maintenance as
outlined in the SERVICE Section.
· Tighten loose nuts and bolts. With a new
machine, check every few hours of operation
until hardware stays tight.
· Replace worn, broken or damaged points (and
wear strips on deep-till shanks).
Hitch
Initially adjust hitch to the approximate correct height
before transporting the implement to the field. The
implement hitch is adjustable to five different vertical
positions to match tractor drawbar height.
Note: Final hitch height adjustment must be made in
the field.
7