ENGLISH
1
Hardware Installation
1.
Install one AAA battery into the mouse and two AAA into the
keyboard.
2.
Plug in your USB receiver to a USB port of your PC.
ID Channel Setting and connection:
Follow these steps:
1.
The Pico dongle is stored inside of the mouse, plug it into a USB
port and wait about 5-10 seconds.
2.
The connection will be executed and the kit will be ready for use.
Replace Batteries
If the mouse or keyboard does not work properly, then the batteries
have lost their charge, so you need to replace them.
Warning: do not mix or use different types of batteries at the same
time.
“Warning (Trouble shooting)
1.
In case the wireless device was not connected when you set the
ID channel setting, check if you have installed the batteries with
the positive (+) and negative (-) polarity in the correct position,
then repeat the ID channel setting again.
2.
For optimum performance, please make sure that the distance
between the wireless device and the micro dongle receiver does
not exceed 10M.