AG SHIELD LandRoller, Руководство оператора и каталог запасных частей

Страница: 51 / 55

51
B) the curve of tire fits precisely into the curve of
the drive spindle when under pressure,
10) IF it does not fit perfectly when under pressure,
shim the spindle end ways using the machinery
bushing, and spacers to hold the spindle in
precisely the correct position. See Figure 35
below with bushing and spacers on the ends of
the spindle.
11) If working in folded transport position, Run a
light chain between the wing sections, so that
the drive spindle cannot rotate the wheels, and
move the wheels to field position. It is easy to
adjust the 2 pressure gauge without walking as
much .
12) Increase the pressures of both sides 100 psi at
a time alternating between the 2 sides. The
correct pressure is 200 psi less than maximum
tractor system or at least 2300 psi.
13) Remove the chain and allow the wings to fold
out. If one moves faster than the other on
similar ground conditions, increase the
pressure setting on the faster wheel to slow
down the speed that the wheel rolls compared
to the other side. The goal is to have the wheel
roll as a similar speed, and both sides arrive at
the fold stop on the center section at the same
time.
14) If one wheel arrives at the fold stop ahead of
the other, check to see that the drive spindle
cannot turn and damage the tire. When the
gauge pressure is high enough, the cylinder will
force the spindle on to the tire tightly enough
that the friction between the drive spindle and
the tire will stop the motor from turning.
15) When both wings have reached the stop, the
tractor system pressure relief should allow both
spindles to stop turning, therefore not
damaging the tire.
16)