12
PRODUCT DESCRIPTION
1.2 Preparing for the Installation
• Due to the high power consumption, always use the plug
exclusively designed for this product. If an extended line is required,
please consult your service agent.
•
The product should be installed on a flat surface to avoid tipping.
The distance between the back of the product and the wall should
be maintained for proper ventilation. Avoid installing the product in
the kitchen, bathroom or any other places with high humidity so as
not to shorten the service life of the electronic components.
• The product can normally operate only under 5000m in altitude. In
installations at altitudes above 3000m, some abnormalities may be
experienced.
1.3 Installing and Removing Table Stands
(optional)
To install table stands:
1
Ensure your display is powered off.
2
Spread a protective sheet on a flat surface.
3
Grab the carrying handles and place the display face-down
on the protective sheet.
4
After inserting the stand in the guide block, tighten the
screws on both sides of the display.
Note:
♦
The longer side of the stand
should face the front of the
display.
To remove table stands:
1
Power off the display.
2
Spread a protective sheet on a flat surface.
3
Grab the carrying handles and place the display face-down
on the protective sheet.
4
Remove screws using a screwdriver and place them in a
safe place for reuse.
Carrying handle
Thumbscrews
Guide block
Table stand
Longer portions
face the front
Warning:
♦
Do not press too hard on the
LCD panel or edge of the
frame, as this may cause the
device to malfunction.
♦
During unpacking, make sure
to hold the carrying handles
to remove the device from its
packaging.
