Ag Leader OnTrac3 MDU-G4, Руководство по установке, Страница: 9 / 26

7
O
N
T
RAC
3
MDU-G4
• The vehicles steering system is in good working order. Drive the vehicle to verify this prior to beginning
the installation. There should be no play in the steering and the vehicle should turn proportionally the
same to the left and right.
• The vehicle’s electrical system and battery must be in good working order.
• The vehicle should be fully cleaned before installing the OnTrac3 system. A clean vehicle will improve the
overall installation and cable routing
If any issues are discovered with the vehicle, they must be repaired prior to beginning the OnTrac3
installation by a qualified service person for the vehicle.
Note:
This installation manual, vehicle specific installation manuals, and sub-kit manuals contains
valuable information for servicing the OnTrac3 system. After the installation is complete, store all of
these manuals in a safe place for future reference.
T
ECHNICAL
S
UPPORT
Contact your Ag Leader Dealer or Ag Leader Technology for technical support.
Telephone: (515) 232-5363
Email: support@agleader.com
V
EHICLE
I
NSPECTION
Prior to installing the OnTrac3 system, confirm that the vehicle and the vehicle’s steering system are in
good working order by driving it around. In addition, verify the following items:
• Verify that you can turn the steered wheels from lock to lock.
• Record the time it takes to turn the vehicle’s steering mechanism (ex. steering axle, articulation point) from
full left to full right and then record the time to go from full right to full left as fast as you can manually.
This will be used later to ensure steering performance is okay.
• Verify the vehicle steers straight and does not pull to one side when driving in a straight line.
• Verify that there are no oil leaks.
• Check for loose or worn steering components.
If any part of the vehicle is not in working order, have the system serviced by a qualified technician prior
to beginning the OnTrac3 installation procedure.