Ag Leader OnTrac3 MDU-G4, Руководство по установке, Страница: 25 / 26

23
O
N
T
RAC
3
C
ABLE
H
ARNESS
I
NST
A
LLATION
O
N
/O
FF
S
WITCH
The MDU-G4 is equipped with an On/Off switch. This allows the
operator to disable the MDU-G4 unit without powering down the
complete steering controller. Position the switch with the 0 to
disable the MDU-G4
The MDU-G4 has 2 LED lights
• When the MDU-G4 is powered, light 1 (A) will be a constant Green.
• When a steering command is given to the MDU-G4 light 2 (B) will
flash Yellow when the wheel is turning.
C
ARE AND
M
AINTENANCE
This chapter describes the required care and maintenance for your OnTrac3 system. Should you require
repair services, spare parts or warranty, contact your OnTrac3 dealer. Only the factory or an authorized
service center has the correct parts and training necessary to service your OnTrac3 system.
• Keep the anti-rotation pin tight at all times. Check the anti-rotation pin every 250 hours of operation or
every six months, whichever occurs first, and tighten as necessary to the specified torque. Do not
operate the OnTrac3 unit if the anti-rotation pin is loose.
• Keep the anti-rotation bracket well secured to the steering column at all times. Check the anti-rotation
bracket every 250 hours of operation or every six months, whichever occurs first, and confirm that it is
secure and all fasteners are tight. Tighten as necessary.
• Keep the Electronic Control Unit (ECU) and associated brackets well secured to the vehicle at all times.
Verify that the ECU is secure every 250 hours of operation or every six months, whichever occurs first,
and tighten as necessary. Do not operate the OnTrac3 system if the ECU is not well secured. A detached
ECU may cause sudden loss of vehicle control while in AutoSteer mode.
• Do not expose your Mechanical Drive Unit (OnTrac3) to water or rain. Store the OnTrac3 in a protected
location. On open platform tractors, remove it from the vehicle when not in use.
• Check all cables and electrical connectors every six months. Secure any loose cables using cable ties.
• Clean the outside surfaces of your Mechanical Drive Unit and the three guide rollers using a damp cloth.
Do not apply spray cleaners, spray waxes, liquids or lubricants such as WD-40. The use of any liquid
cleaning agent or lubricant may damage the internal components of your Mechanical Drive Unit and will
void the factory warranty.
• Always clean the main gear and main gear race with a damp cloth to remove dust before installing the
OnTrac3 to the steering wheel. This is especially important when moving the OnTrac3 between vehicles.
• The Mechanical Drive Unit is manufactured with sealed bearings and self lubricating components and
does not require lubrication. Do not apply oil, grease or spray lubricants.