11
Mounting
EN
TAS 03
5
Mounting
5.1
Preparing mounting
Verify that the area X (with stagnant water) is as short as possible.
Verify that the product is connected to the hot water outlet of the water
heater or to the inlet of the safety heat exchanger.
Verify that the capillary tube is not bent or squeezed.
Verify that the pocket is installed in the upper part of the boiler.
Verify that the thermal safety valve is installed with the correct direction of
flow as indicated by the arrow.
The capillary tube can be mounted as required. The upper plastic parts can
be aligned in the desired direction.
1. Loosen the union nut.
2. After the alignment, fully retighten the union nut.
WARNING
SCALDING DUE TO HOT LIQUID
Water in heating systems is under high pressure and can have temperatures of
more than 100 °C.
•
Verify that the heating water has cooled down before mounting the product
to the system.
•
Verify that hazards caused by hot water/vapour at the free outlet of the dis-
charge line into the funnel are excluded.
Failure to follow these instructions can result in death, serious injury or
equipment damage.
