Mounting and commissioning
Unimes E
13
1.
Adjust the length of the float wire to the tank height according to
the illustration below:
1
Height of flange
connection piece
2
Fixed lead seal
3
Ø or height
2.
Hold the float wire in this position.
3.
Turn the adjustment screw to set the pointer to zero.
The direct indication gauge is now adjusted to the tank.
6.5
Connecting the direct indication gauge and the remote indi-
cator
Plug the connector of the connection cable into the rear side of
the direct indication gauge.
6.6
Connecting the battery of the remote indicator
1.
When the direct indication gauge and the remote indicator are
electrically connected, open the housing of the remote indicator
by turning the upper part all the way to the stop and pulling it
open.
