FTS 1
FIBER OPTIC TALK SET
OPERATING INSTRUCTIONS
• To establish a voice link, two FTS 1 Talk Sets
must be connected to a designated optical fiber
using appropriate multimode or singlemode
jumper cables.
• Once connected and the headset is plugged
into the headset port on the top panel, turn
on the FTS 1.
• The FTS 1 will automatically begin looking for
the talk set at the far end. Within three seconds
the communication link will be established,
and the LED on the top panel will change from
red to green.
• The volume is adjusted by turning the knob
on the top panel.
LED STATUS
GREEN - Linked
BLINKING - Low Battery
RED - Not Linked
OFF - Insufficient Power
MAINTENANCE
The optical fiber connector must be kept
free from dirt or other contaminates. Most
contaminates can be removed by using a can
of compressed air. It is important to keep the
dust cap in place when not in use.
To replace the 9 volt alkaline battery, remove
the rubber boot and the cover to the battery
compartment.
FTS1-00-1000 Rev. F 2010-10-07
