AFF 862ASD, Инструкция по эксплуатации, Страница: 4 / 23

Page 4
Prohibited Dangerous Actions
This section describes examples of dangerous actions not only during equipment operation, but also during
maintenance and inspections. To avoid accidents, thoroughly read and understand the instructions below regarding
dangers related to each mechanism prior to any maintenance or inspection work.
1) Use a qualified person to keep the lift in good condition. Keep it clean for best and safest performance.
2) The maximum load is 150 Ton,
DO NOT exceed this rated capacity. Never apply excessive force to a work piece and
always use the pressure gauge to accurately determine the applied load. Burst hazard exists if hose or connection
pressure exceeds rated pressure.
3) Shop presses are designed for automotive, truck, implement, fleet, and industrial repair shops where
pressing, bending, straightening, forming or holding is required. Each press includes a cylinder, a pump, and
lifting bar which provides a safe way to raise and lower the bed frame, and a pressure gauge for monitoring
the applied press force.
4) Keep children and unauthorized persons away from the work area.
5) Remove loose fitting clothing. Remove ties, watches, rings and other loose jewellery, and contain long hair.
6) Wear ANSI approved impact safety goggles, full-face impact safety shield and heavy-duty work gloves when
operating the press.
7) Keep proper balance and footing, wear nonskid footwear and do not overreach.
8) Only use this press on a surface that is stable, level, dry and not slippery, and capable of sustaining the load.
Keep the surface clean, tidy and free from unrelated materials and ensure there is adequate lighting.
9) Inspect the press before each use. Do not use if bent, broken, cracked, leaking or otherwise damaged, any
suspect parts are noted or it has been subjected to a shock load.
10) Check to ensure that all applicable bolts and nuts are firmly tightened.
11) Ensure that work piece is center-loaded and secure.
12) Keep hands and feet away from bed area at all times.
13) Do not use the shop press to compress spring or any other item that could disengage and cause a potential
hazard. Never stand directly in front of loaded press and never leave loaded press unattended.
14) Do not operate the press when you are tired or under the influence of alcohol, drugs or any intoxicating
medication.
15) Do not allow untrained persons to operate the press.
16) Do not make any modifications to the press.
17) Do not use brake fluid or any other improper fluid and avoid mixing different types of oil when adding hydraulic
oil. Only good quality hydraulic jack oil can be used.
18) Do not expose the press to rain or any other kind of bad weather.
19) If the press needs repairing and/or there are parts that need to be replaced, have it repaired by authorized
technicians and only use the replacement parts supplied by the manufacturer.
WARNING: The warnings, cautions and instructions discussed in this instruction manual cannot cover all possible
conditions and situations that may occur. It must be understood by the operator that common sense and caution are
factors which cannot be built into this product, but must be supplied by the operator.
Environmental Pollution
If the substances you use come under the ordinances concerning environmental pollution, follow the ordinances to
discharge and dispose of such substances. If you commission industrial waste companies, you should confirm the
way of final processing.