AFF 862ASD, Инструкция по эксплуатации, Страница: 3 / 23

Page 3
Hazards
Personnel safety must have top priority. Thoroughly read the operation manuals to completely understand proper
procedures before maintenance or inspection work.
Basic Safety Instructions
Failure to comply with the following could result in serious injury or death.
1) Periodic inspections or maintenance work must be carried out by two or more persons.
2) Read and understand the safety manual.
3) Read and understand all the attached manuals.
4) Attach visible signs on the equipment so that everyone recognizes and understands that maintenance or
inspection is ongoing.
5) Post a list with emergency phone numbers nearby the working area.
6) Operator should be aware of what to do in case of an emergency (refer to the Procedures for Emergency
Situations); know the location of the first-aid-kit, and the location of the fire extinguisher. Also learn how to
use a fire extinguisher.
7) Alert anyone around the Tool whenever planning to operate it during maintenance or inspection work.
8) Always use proper hand tools and jigs during maintenance or inspections. Before operating the machine,
check for any hand tools or jigs left inside it. For your own safety, NEVER try to remove them with the
machine under operation. Consider SAFETY FIRST .
9) The operator must wear protective clothes, gloves, safety helmet, shoes and ear protection during
operation.
10) To prevent back injury, heavy parts (or units) must be moved by two or more persons.
11) Before powering the machine, alert the persons around it.
12) Be careful not to be pinched by moving parts.
13) Use
ONLY CARRIER specified for the tool, and set it in a correct position.
14) To avoid accidents, always be aware of any on-going work on the machine. Also, always stay focused on
the job to be done.
Safety Instruction and Warnings
1. Before maintenance on pressured parts in the machine, you MUST release the pressure in the pressured
system. At the same time, DO NOT stand in the direction facing the charger, the operator should be on the
opposite side and remember DO NOT strike, press or transfer until it is discharged.
2. When it is necessary to exchange die after running, operators should wear gloves or use tools to operate and
avoid injury.
IMPORTANT
This press is shipped with a removable Guard, determine if the included guard is appropriate for the
application, due to the wide variety of pressing / bending applications, it is impossible to incorporate one
guard that will apply to all applications. ALWAYS ENSURE THAT THE OPERATOR AND BYSTANDERS ARE
PROPERLY GUARDED FROM THE POSSIBILITY OF FLYING DEBRIS.
NOTE :
Immediately stop operating the equipment if not working properly. Contact certified technical support engineers
for repair. The equipment must not be operated without approval from the certified technical support engineer.