Afag SREH-50-IOL, Руководство по сборке и эксплуатации, Страница: 31 / 52

Installation, assembly and setting
Assembly instructions EN

SREH-50-IOL

Date 17.06.2022

Version 1.0 31–52
6.3 Electrical interfaces
Please refer to the software manual accompanying the SREH-50-IOL. This
contains further information on the IO-Link interface.
DANGER
Danger of electric shock when connecting the module connector!
There is a risk of electric shock if the module connector is not connected
properly.

The electrical connection of the module must be made via an M12
connector (  Chapter 6.3.1) which can provide the electrical specifications
of the module according to the manufacturer's specifications.

Before loosening the plug connection, make sure that the connecting cable
is de-energised and secured against being switched on again.
WARNING
Danger of collisions!
By controlling the decentralised controller in the module via the IO-Link
interface, there is a risk that movements are specified that can lead to
collisions.

When working on the module, the motor supply must be switched off and
only switched on again after the work has been completed.

If it cannot otherwise be ruled out that persons move within 2 [m] of the
module, visual contact from the person to be controlled to the module must
be ensured.

When lines are laid from the installation to the flange, over-turning of the
flange by 360° must be prevented. This can be done with the help of the
rotation limitation.
WARNING
Danger due to premature or faulty control!
Premature or incorrect control of the module can cause the output flange to
rotate.

Do not connect the plug/motor supply to the output flange until the module
and components have been fully assembled.

Before carrying out any work in the area of the module, disconnect the
motor supply and secure it against being switched on again!