Installation, assembly & setting
28 – 52
Assembly instructions EN
SA-1 I SA-1-FL
Edition 01/2021
Rev. 3.5
6.3.2 Adjusting the motor position
Fig. 7
Adjusting the motor position
1. Cover
2. 1 x Screw M3x6
3. 4 x Screws M3x6
4. Housing
Procedure for changing the position of the motor:
1. Switch off the controller of the module.
2. Remove the screws M3x6 (Fig. 7, 2) and dismount the cover (Fig. 7, 1).
3. Loosen the 4 x screws M3x6 (Fig. 7, 3).
4. Rotate the housing (Fig. 7, 4) 90° to the left or right (swivel).
5. Tighten 4 x screws (Fig. 7, 3) M3x6 with a tightening torque of 1.4 Nm.
6. Mount and fasten the cover (Fig. 7, 1).
7. Reassemble all necessary cables.
8. Connect the controller unit.
The adjustment of the motor position is completed.
After adjusting the motor position, the telescope spindle axis must be re-
referenced (
see instructions of the controller manufacturer).
The correct toothed belt tension must be maintained and must
NOT
be
changed!
1
2
4
3