Afag 11001864, Руководство по сборке и эксплуатации, Страница: 37 / 52

Commissioning
Assembly Instructions EN

LM 12 I LM 16

Edition 11/2020

Rev. 2.5 37–52
7.2 Preparatory activities for commissioning
Before commissioning, adjust the shock absorber and the lifting/stop screw
so that the intended stroke is correctly damped.
7.2.1 Adjusting the shock absorbers (shock absorber SD 08/06)
In order to achieve a smooth movement sequence, the lifting movement (H) is
stopped in end position against the stop screws by means of shock absorbers.
Fig. 18 Adjusting the shock absorbers
Procedure for adjusting the shock absorbers:
1. For the stop screw AS 08/25 and AS 80/40, press the stop pin (max. 3 mm)
completely in (min. 2 mm).
2. Screw in the shock absorber (Fig. 18, 1) until the pin protrudes at least 1
mm.
3. Fasten the shock absorber with the fixing nut (Fig. 18, 2).

Das The maximum tightening torque of the nut must not exceed 1.7 Nm!

The adjustment of the shock absorbers is completed.
The stroke (H) must be limited by the stop (Fig. 18, 4) - not by the shock
absorber!
If the shock absorber is used as a stop the shock absorber can be damaged
and become unusable!