Instruction manual for use and maintenance - EN
Rev.: 0
–
aggiornato al 06/11/2020
| Con riserva di modifiche tecniche e salvo errori |
Pag.
6
di
39
2.6.
Warning about specific dangers
All work on the electrical device of the unit shall be carried out exclusively by a qualified
electrician or by personnel with the necessary training, under the direction and supervision
of a qualified electrician and in accordance with the relevant safety standards.
Before any activity on the unit, it is necessary to disconnect the electric plug from the mains
supply, to prevent accidental restarting.
Use only original fuses with the prescribed current limit.
All electrical components to be inspected, maintained and repaired must be disconnected.
Block the devices used to disconnect the voltage, in order to avoid accidental or automatic
restart.
First check the absence of voltage on the electric components, then isolate the adjacent
components. During repairs, be careful not to modify the factory parameters so as not to
jeopardize safety.
Check the cables regularly and replace in case of damage.
Skin contact with welding powders etc. can cause irritation to sensitive people.
Repair and maintenance of the unit must only be carried out by qualified and authorized
personnel, in compliance with safety requirements and accident prevention regulations in
force.
Danger of serious damages to respiratory system.
To prevent contact with dust and inhalation, use protective clothing and gloves and an
assisted ventilation device to protect the respiratory tissue.
During repairs and maintenance interventions, avoid diffusion of dangerous dust, in order
to prevent health damage even of people not directly affected.
The unit can produce noise emissions, specified in detail in the technical data.
If used with other machinery or due to the characteristics of the place of use, the unit may
generate a higher sound level.
In this case, the person in charge is required to provide the operators with adequate
protective equipment.
DANGER
WARNING
WARNING
