Instruction manual for use and maintenance - EN
Rev.: 0
–
aggiornato al 06/11/2020
| Con riserva di modifiche tecniche e salvo errori |
Pag.
5
di
39
2.4.
Safety warnings for the operator
Before using the unit, the operator in charge must be suitably informed and trained for the use of the
unit and the relevant materials and means.
The unit must only be used in perfect technical condition and in compliance with the intended purposes,
the safety standards and the warnings relating to dangers as reported in this Manual.
All failures, especially those that can jeopardize safety, shall be removed immediately!
Each person responsible for commissioning, use or maintenance of the unit must be familiar with these
instructions and must have understood their content, especially paragraph 2 Safety.
It is not enough to read the manual for the first time when you are already working.
This is especially true for people who work on the unit only occasionally.
The manual shall always be available near the unit.
No liability is accepted for damage or injury due to failure to comply with these instructions.
Observe the current workplace precaution rules, as well as other general and standard technical safety
and hygiene tips.
Individual responsibilities for the various maintenance and repair operations must be clearly established
and respected. Only in this way malfunctions can be avoided - especially in dangerous situations.
The user shall ensure that the personnel responsible for use and maintenance of the unit shall wear
personal protective equipment (PPE). These are mainly safety shoes, goggles and protective gloves.
Operators must not wear long loose hair, baggy clothing or jewelry! There is a risk of being trapped or
drawn in by the moving parts of the unit!
In case of any changes on the unit, that may affect safety, switch off the equipment immediately, secure
it and report the incident to the department / person in charge!
Interventions on the unit can only be carried out by competent, reliable and trained personnel.
Personnel undergoing training or in a training program may only be permitted to work on the unit under
the constant supervision of a trained person.
2.5.
Safety warnings for maintenance and troubleshooting
For all maintenance and troubleshooting, ensure to use suitable personal protective equipment.
Before proceeding with any maintenance work, clean the unit.
An industrial vacuum cleaner with H efficiency class for dust can be helpful.
The preparation, maintenance and repair operations, as well as the detection of faults can only be
carried out if the unit is without power supply:
•
Remove the plug from the mains supply.
All screws that were loosened during maintenance and repair work need always be fastened again!
If so foreseen, the screws must be tightened with a torque wrench.
Before proceeding with maintenance and repairs it is necessary to remove all impurities, especially on
the parts fastened with screws.
