AIR+
Rev 00.00
Pag. 14 di 20
©| Aerservice Equipments S.r.l. | 2020 all rights reserved
é vietata la riproduzione del presente manuale, anche parziale.
OPERATING THE UNIT
TURNING THE UNIT ON / OFF
Press the power button
on the Control Panel or Remote to turn the unit on. The unit will initially be set
to “NORMAL” Mode. Press the Power Button once more to turn the power off.
USING “NORMAL” MODE
Press
button until “NORMAL” is shown in the lower right of the display.
•
Square meters not vailable in “NORMAL” mode (see Initial Settings).
•
To control the fan speed: use
or
buttons in
menu.
USING
“HIGH” MODE
Press the
button until “NORMAL” is shown in the lower right of the display.
•
To set the square meters on the display: use
or
b
uttons (see “Initial Settings”)
•
To control the fan speed: use
or
buttons.
CAUTION:
never adjust setting to exceed square meters of ventilated space being treated..
USING
“AWAY” MODE
Press the
button and verify that “AWAY” is shown in the lower right of the display.
•
To set the “AWAY” mode timer: press
. Each press of the
button increases the running time of
the AWAY mode. Select 0:30, 1:00 or 2:00 hours.
•
Press
once more to switch the unit back to
“NORMAL” mode.
LCD REMINDERS
REPLACE PLATE
When “REPLACE PLATE” appears, the Purification Plate has reached the end of its useful life and must be
replaced. To order a replacement, contact your distributor. Once a replacement has been obtained, follow
the instructions in “DISASSEMBLY/ASSEMBLY” to replace your old Purification Plate with your new one.
REPLACE PCO CELL
When “Replace PCO Cell” appears, the PCO Cell has reached the end of its useful life and must be replaced.
Contact your distributor to order a replacement.
Once a replacement has been obtained, follow the instructions in “DISASSEMBLY/ASSEMBLY” to replace
your old PCO Cell with your new one.
PERFORM CLEANING
“PERFORM CLEANING” will display once the 30 day operation cycle between cleanings has passed and
the unit requires a complete cleaning. Follow the instructions in “CLEANING”.
After replacing the Purification Plate or the PCO Cell, the corresponding reminders will reset themselves.
After performing a cleaning of the unit you should reset the reminders by holding down the Reminder Reset
button
on the Control Panel of the unit. The reminder has been reset when “PERFORM CLEANING”
no longer appears.
