AeroWorks 100cc YAK-54 ARF-QB, Инструкция по сборке

Страница: 18 / 89

18
9. Ensure both servos do not fight each other at
center or either end point at full deflection.
Note: Take advantage of servo programmers and
match boxes available today to achieve best
results. This will help keep servos from bind-
ing and possible aileron flutter.
10.
Repeat all the above steps for the other wing.
8. Plug the servos into the receiver and turn on.
Ensure servos are centered and the servo arms
are parallel to the aileron hinge line. Adjust
the length of the pushrods so that the aileron is
at the neutral position when the servo arms are
parallel to the aileron hinge line. Carbon reinforcement tube installation
1. Gather
the supplied carbon tube for
reinforcing the aileron pushrods. Wrap
masking tape around carbon tube for marking
the cut location.
2. Mark cut location onto carbon tube. Carbon
tube should fit between 4-40 ball link lock
nuts.
Note: Model shown may be different form yours.
However, the carbon reinforcement tube
installation will remain the same for your
model.