Aerotech XL4s, Руководство по оборудованию, Страница: 20 / 52

2.1.2. Motor Supply Connector
IMPORTANT : To operate correctly, this product must have a power supply connected
to the Motor Supply and a power supply connected to the Control Supply.
Motor power is applied to the XL4s at the four terminals of the Motor Supply connector. The DC+
input and the DC- input are connected to fuses inside the drive. Refer to
Table 3-5 for fuse values
and part numbers.
IMPORTANT : Refer to local electrical safety requirements to correctly size external
system wires.
DANGER : To prevent the risk of electric shock, do not operate the XL4s without a
ground connection.
Figure 2-2: Motor Supply Connections
Table 2-3: Motor Supply Wiring Specifications
Pin Description
Recommended
Wire Size
(1)
DC+ +40 VDC Input Range 2.1 mm 2 (#14 AWG)
RET Return for DC Input 2.1 mm
2
(#14 AWG)
DC- -40 VDC Input Range 2.1 mm
2
(#14 AWG)
Protective Ground 2.1 mm
2
(#14 AWG)
(1)The wire insulation is rated for 300 V.
Table 2-4: Mating Connector Part Numbers for the Motor Supply Connector
Type
Aerotech
P/N
Third Part
P/N
Screw
Torque: N·m
Wire Size:
mm 2 [AWG]
4-Pin Terminal Block ECK002407 Phoenix 1758843 0.5 - 0.6 3.3 - 0.0516 [12-30]
2.1.2. Motor Supply Connector XL4s Hardware Manual
20 www.aerotech.com