Aerotech AGV-SPO Series, Руководство по оборудованию

Страница: 34 / 48

3.2. Motor and Feedback Wiring
DANGER : To decrease the risk of electrical shock, injury, death, and damage to the
equipment, obey the precautions that follow.
l
Make sure that all components are grounded correctly and that they obey the local
electrical safety requirements.
l
It is the responsibilty of the system integrator or qualified installer to determine and
meet all safety and compliance requirements when they integrate the AGV-SPO into
a completed system.
l
Restrict access to the galvo when it is connected to a power source.
AGV-SPO scan heads are wired and assembled at the factory. Contact your Aerotech representative
if you have any questions on system configuration. For cable drawings, refer to the documentation
that shipped with your system.
Table 3-3: Aerotech Motor and Feedback Cable Part Numbers
Aerotech Controller Nmark GCL or Automation1 GL4
Cable Application Standard Hi-Flex
Interface Cable Part Number C23680-xxx
(1,2)
C23690-xxx
(1,2)
(1) -xxx = Cable Length in Decimeters (1 Decimeter = 3.937 inches)
(2) Contact the factory for standard and custom length cables
3.2. Motor and Feedback Wiring AGV-SPO Hardware Manual
34 www.aerotech.com