3-13. Using the above steel braided hose assemblies, connect one end to the Y-block and the other end to the fuel rails,
as shown in figure 3-1, and tighten.
Figure 3-2
3-14. Starting from the outlet of the fuel filter, plan a route to run an AN-08 supply line from fuel filter to the Y-block, see
figure 3-3, this line should be run along the same route you planned to run the return line in step 1.27. Cut the
supply line to the determined length and install the AN-08 hose ends, as detailed in Section 4.
Note: Be sure to route all fuel lines clear of any moving suspension or drivetrain components and any exhaust
components! Protect fuel lines from abrasion and road obstructions or debris.
3-15. Using the above steel braided hose assembly, connect one end to the outlet of the fuel filter. Keeping both the
supply line and return line from the Aeromotive fuel tank together, secure both lines to the vehicle along the
predetermined route using the supplied tie-wraps. Once both lines are routed, the supply line to the Y-block and the
return line to the bottom of the regulator, as shown in figure 3-3, tighten all fittings.
Note: Be sure to route all fuel lines clear of any moving suspension or drivetrain components and any exhaust
components! Protect fuel lines from abrasion and road obstructions or debris.
Figure 3-3
3-16. Once the regulator is installed, attach the supplied fuel pressure gauge to the 1/8 NPT port on the fuel pressure
regulator. Use teflon tape on this connection.
