Aerohive Networks Aerohive AP141, Справочник по аппаратуре

Страница: 77 / 111

Chapter 7 The AP340 Platform
76 Aerohive
Figure 10 Attaching the AP340 to the mounting plate and connecting cables
When done, adjust the ceiling tiles back into their former position.
Locking the AP340
To lock the AP340 to the mounting plate, use either a Kensington lock or the lock adapter that is included
with the mounting kit and a small padlock (not included).
To use a Kensington lock, loop the cable attached to the lock around a secure object, insert the T-bar
component of the lock into the device lock slot on the AP, and then turn the key to engage the lock
mechanism.
To use the lock adapter:
1. Insert the T-shaped extension on the adapter into the device lock slot, and rotate it clockwise so that the
curved section extends through the slot in the mounting plate (see Figure 11 ).
Figure 11 Locking the AP340 to the mounting plate
2. Link a padlock through the opening in the adapter and engage the lock to secure the AP340 to the
mounting plate. The opening is 1/8" (0.3 cm) in diameter at its narrowest.
You can tie the cables to the tie points (small arched strips) on the mounting plate to prevent them
from being pulled out of their connections accidentally.
With the AP upside down, align
its port side with the bottom end
of the plate.
Push the AP upward, inserting
the four tabs on the plate into
the four slots on the AP.
Slide the A toward the bottom
end of the plate, locking the tabs
inside the slots.
Attach the antennas and
connect the cables to
complete the installation.
4
6
7
5
Tab inside
slot
Tab locked
in place
Mounting plate
AP (shown as transparent for clarity)
Tab
Slot
Mounting plate
AP
Ceiling
Cables pass through the hole in
the mounting plate and ceiling
5 GHz (A) 5 GHz (B) 5 GHz (C)
Rotate the
lock adapter
clockwise
Insert a lock
through the
opening
AP
Mounting plate