1 |
P a g e
40 Huntingwood Drive Huntingwood NSW 2148
Phone: (02) 8825 1999 Website:
AEROFLOW PERFORMANCE
RED FUEL PUMP
WARNING!
THIS PRODUCT REQUIRES DETAILED KNOWLEDGE OF AUTOMOTIVE SYSTEMS. WE RECOMMEND THAT THIS INSTALLATION BE
CARRIED OUT BY A QUALIFIED AUTOMOTIVE TECHNICIAN.
INTRODUCTION
Congratulations on your purchase of the Aeroflow Performance red fuel pump. Aeroflow Performance products cannot and will not be
responsible for any damage, or other conditions resulting from misapplication of the parts described herein. However, it is our intention to
provide the best possible products for our customer, products that perform properly and satisfy your expectations. Should you have any
questions? Please call technical support at +61 2 8825 1900 and have the product part number on hand when calling.
The Aeroflow Performance Red, Blue and Black fuel pumps are a proven rotor / vane design that is known to get the job done in an affordable
package for your carburettor fuel system.
The RED fuel pump is a low-pressure fuel pump which operates at a free flow 97GPH at a set pressure of 7PSI (0.48BAR) and does not require
the use of any fuel regulators. This meets the flow requirements of most carburettor vehicles.
This motor draws 2 amps current and an 8amp
fuse is recommended.
These fuel pumps MUST be located below and as close to the tank as possible. This is necessary to allow for an adequate fuel supply. The
pump is designed to push fuel and NOT designed to suck fuel out of the tank. It needs to be gravity-fed or if its pulling from the top of the tank,
it needs to have a siphon feed to the pump. The pump should be mounted on the chassis, in a vertical position with the pump motor on top.
Avoid exposure of the pump and fuel lines to moving parts and any extreme heat areas, such as the exhaust or
any sources of water. The
pump should not be mounted in a closed area, such as the vehicles trunk. They can be serviced from the pump end with repair kits that are
readily available.
All fuel pumps feature two female 3/8 NPT ports on either side.
Overall Length = 93mm (3-21/32”)
Overall Width = 79mm (3-7/64”)
Overall Height = 140mm (5-33/64”)
Centre to Centre of mounting tabs on bracket = 60mm (2-23/64”)
This fuel pump is only suited for regular unleaded petrol. It will not suit alcohol, E85, methanol or diesel fuels due to the
corrosion nature of these fuels. If using any of these fuels we recommend the Aeroflow Black Fuel Pump AF49-1010.
The factory fuel pump wiring may not be sufficient to handle the current draw of this fuel pump. Please update all wiring if necessary and add
in a relay to ensure pump works correctly. If using the existing electrical plugs and wiring in vehicle ensure correct polarity is used on the new
pump. If necessary, re-pin the existing one or use the included plug.
This fuel pump is only one component of your vehicles complete fuel system. Please ensure the vehicles complete fuel system is up to the task
of supplying the right amount of fuel to your engine. Failure to do so may result in severe engine damage and damage to other related
components.
For more information or technical enquires
Contact: Aeroflow Performance on
Phone: (02) 8825 1979 Website:
www.aeroflowperformance.com
