1 |
P a g e
40 Huntingwood Drive Huntingwood NSW 2148
Phone: (02) 8825 1999 Website:
INSTALLATION MANUAL
AEROFLOW PERFORMANCE
NITROUS BOTTLE BRACKETS
WARNING!
BEFORE PROCEEDING WITH INSTALLATION PLEASE READ INSTRUCTIONS CAREFULLY. THIS PRODUCT REQUIRES DETAILED
KNOWLEDGE OF AUTOMOTIVE SYSTEMS. WE RECOMMEND THAT THIS INSTALLATION BE CARRIED OUT BY A QUALIFIED
AUTOMOTIVE TECHNICIAN.
THE INSTALLATION OF THIS PRODUCT REQUIRES THE HANDLING OF NITROUS OXIDE. WE RECOMMEND TO WORK IN A WELL
VENTILATED AND WEAR APPROPRIATE SAFTEY WEAR FOR PROTECTION.
KEEP ALL IGNITION SOURCES AND OPEN FLAMES AWAY FROM VEHICLE AT ALL TIMES WHILE INSTALLING THIS PRODUCT.
WE RECOMMEND TO INSTALL THIS WITH AN EMPTY BOTTLE WHEN FIRST MOUNTING THIS PRODUCT.
INTRODUCTION
Congratulations on your purchase of Aeroflow Performance billet nitrous bottle brackets. Aeroflow Performance products
cannot and will not be responsible for any damage, or other conditions resulting from misapplication of the parts described
herein. However, it is our intention to provide the best possible products for our customer, products that perform properly and
satisfy your expectations. Should you have any questions? Please call technical support at +61 2 8825 1900 and have the product
part number on hand when calling.
The Aeroflow Performance nitrous bottle brackets are machined on the correct angle and feature double O-rings machined into the bracket to
not only hold the bottle firmly into place but will also prevent any damage to the bottle itself. These brackets also open up a full 180 ® for easy
bottle replacement.
It is important to mount your bottle in the proper orientation. Ideally, the bottle should be facing with the valve to the front of the vehicle. This
is because the siphon tube inside the bottle is curved towards the bottom of the bottle, so it can pick up a steady supply of nitrous. These
brackets allow you to mount the bottle at the correct angle to avoid any issues with supply. It is recommended to mount the brackets and
bottle with the valve facing towards the front of the vehicle, this is because upon acceleration the nitrous will not be pulled away from the
siphon tube. With it at this angle it still allows the siphon tube to be submerged in the nitrous. If you wish to mount the brackets and bottle
sideways or at a different angle,
you’ll need to rotate the bottle so that the siphon tube is at a 45° angle. This means the bottle nipple will be
facing towards the back of the vehicle at a 45° angle.
When mounting and assembling these brackets on the bottle the short bracket should be on the bottom of the bottle and the top bracket
which is the taller bracket should be towards the valve or front of the bottle. NOTE: these brackets must be a specific distance apart to avoid
damage to brackets and bottle:
I.
10 LB bottle the distance from the bottom of the bottle to the bottom bracket approximately 2-
3/4” (
69.85mm) and the distance
from the bottom of the bottle to the top bracket approximately 11-
3/4” (
298.45mm).
II.
15 LB bottle the distance from the bottom of the bottle to the bottom bracket approximately 2-
3/4” (
69.85mm) and the distance
from the bottom of the bottle to the top bracket approximately 15-
3/4” (
400.05mm).
