Aerial AD 740 Series, Инструкция по эксплуатации

Страница: 18 / 33

Page 16 of 29
The energy consumption of the units connected to the unit socket (figure 1, item
6 on
page 7) is not counted by the calibrated watt meter (item 7).
Commissioning
The air dehumidifier must have been properly installed and connected (chapter 5,
from page 10) before it can be commissioned.
Before commissioning the air dehumidifier allow it to rest in its
final position for about 15 minutes after transport. During this
time, the oil distributed in the cooling system and churned up by
transport will flow back to the compressor. This procedure will
extend the service life of the compressor.
1. Connect the power cable to the power outlet.
2. Ensure that the water tank is installed in the air dehumidifier or a drain hose
(option) has been properly fitted and laid to a collecting vessel or an outlet.
3. Press the On/Off button (Fig. 8, item 6) on the operating panel. If the air
dehumidifier has been correctly connected and the existing humidity is higher
than the set humidity value, the air dehumidifier will start to work. The last
values for hygrostat, language and fan step are taken over, where applicable.
Operator control
1. Use the arrow keys for lowering or increasing the room humidity to set the
requested humidity.
If the existing humidity is higher than the set value, the air dehumidifier will
start to work. If the existing humidity is lower than the set value the air
dehumidifier will not start to work.
During operation condensate is produced. This condensate can either be fed
directly to an outlet via the condensate drain hose or collected in the water
tank. The air dehumidifier switches off when the water collecting tank is full.