AENO AAP0004, Инструкция по установке и эксплуатации

Страница: 32 / 43

Installation and Operation Manual
AENO
TM
air purifier
Document version: 1.0.2, aeno.com © ASBISc Enterprises PLC. All rights reserved
Page 32 of 43
Figure 10 – Prohibition of contact with water
Allow the filter to completely dry for at least 24 hours in a warm, dry place before
reinstalling it. Do not use a clothes dryer, hair dryer, oven, etc.
After drying, reinsert the filter. Install the bottom
cover on the device by turning it clockwise.
3.2.2 Changing the filter
After 2200 hours of operation, the device emits s serie of short beeps and the indicator
of the "FILTER" button starts flashing. This means that the combined filter of the
purifier is dirty and needs to be replaced.
Press and hold the "FILTER" button for 3 seconds. The button light will stop flashing.
Next, replace the filter by following the instructions below.
If you do not replace the used filter, the purifier will continue to work, but the quality
of the air purification will not be satisfactory.
To change the filter, turn the device upside down and place it on a horizontal surface.