12
Simple Logger
®
Models L320 / L410 / L430
Select
Port
from the menu bar and select the Com port (COM 1, 2 3 or 4)
you will be using (see your computer manual). Once the software automati-
cally detects the baud rate, the logger will communicate with the computer.
(ID number of the logger and number of points recorded displayed).
Select
Download
to display the graph. (Takes about 90 seconds.)
Select
File
from the menu bar, then Scaling and the Range of your logger.
4.3.1 Scale and Engineering Unit Programming
The Simple Logger
®
Models L320, L410, and L430 allow the operator to pro-
gram the values for scale and engineering units from within the software.
This permits the user to display the recorded data on the graph or in the
tabular listing directly, in the units appropriate to the measurement, rather
than mathematically converting a voltage or a current to the proper scale
and value after the graph is displayed.
Scales can be programmed from two locations in the software:
•
File
menu option:
Use this option to create a library of scales to use
with DC voltage and DC current loggers. This will allow the user to
select a number of predefined scales.
•
Scale
menu option:
Use this option to create scales for loggers con-
nected to the serial port for downloading.
The Simple Logger
®
software allows the operator to define up to 17 points
along the scale for DC current measurement and up to 11 points for DC
voltage measurement type loggers.
Any combination of points may be used to create the scale, which allows
the user to plot both linear and non-linear data. (See Figures 2 and 3).
Figure 2
Figure 3
Содержание Simple Logger L320
Страница 1: ...SIMPLE LOGGER DC MODULE L320 L410 L430 E N G L I S H User Manual...
Страница 26: ...24 Simple Logger Models L320 L410 L430 Notes...
Страница 27: ......
