Power Quality Analyzer Model 3945-B
57
5.6 Recording Mode
After a recording is set, the instrument will go into sleep mode (no display) to
save the batteries. The recording will start as programmed. Press any button
other than the ON/OFF button to turn ON the display again. Turning off the
PowerPad
®
clears the schedule, even if turned on again, the recording will
not start.
This mode enables all the parameters previously configured in the setup
mode
to be recorded (see § 4.1.8). Press the record display mode button -
The variable function buttons have the following functions in this mode:
- Creates a new recording
- Opens a previous recording
- Deletes recording
5.6.1 Saving the Selected Parameters
07/25/02 10:56
100%
NEW RECORDING
CONFIGURATION : CONFIG 1
START
: 07/25/02 10:56
END
: 07/25/02 10:57
PERIOD
: 1 min
NAME
: T E S T
Recording
2
1
Figure 5-19
Recording status bar (displays remaining memory capacity).
Parameters - press the
buttons to select the parameters and the
but-
tons to modify them. An underline will appear under the selected parameter.
- Select the configuration number to be modified with the
buttons.
(CONFIG 1, 2, 3 or 4)
- Select the dates with the
buttons.
NOTE:
The dates are adjusted according to the chosen recording inte-
gration period. “PERIOD” does not refer to a sampling period, but rather,
to an integration period (average).