AEG Vampyr 6000, Записи по ремонту

Страница: 4 / 4

- 4 -
TSE-N 05.00 A. B. 599 50 77 62 EN
Control Panel ?,
Rocker Switch 5
6 Unlock the control panel, take off the rocker switch, put in the
rocker switch again with mounted-on adjusting spring and lock in
the control panel with the compression spring.
Rotary Electronic 27 Put in the rotary potentiometer into the device in support part 8.
Sliding Electronic 21 Insert the gear wheel symmetrically into the sliding part with the
slide potentiometer and apply it in the centre of rack and guide bar
move the complete unit to the right to the end of the rack and put
on the slider panel 20 with slider 19 the end stop at the right side;
in doing so, check the function whether the slide potentiometer is
guided by slider 19.
Slider
19
Lever the slider using a screwdriver between slider and panel.
During assembly put in the angle spring into the neck of the slider
and lock in the slider using a screwdriver.
Brake Lever 23 Expand the support (2 legs) using circlip pliers.
Lower Housing 24 Unscrew the 7 screws (1 of them below the microfilter box 12).
Microfilter Key 12 Press from outside to inside and unlock.
Wheel 26 Has to be unlocked with a screwdriver or pliers, if necessary lever
with a screwdriver between lower housing 24 and wheel.
Front Wheel 25 Lever with a screwdriver between lower housing 24 and wheel,
additionally unlock the neck in the middle with pliers or another
screwdriver.
Plug Box 9 Press up the snap-in catch in the cable roller box and move a bit
outward, now press the plug box together from the outside and
unhinge the hang-in catches above and below.
Plug Funnel 10 Push out of the guide (cable roller side) upward. During assembly
the plug funnel must be pushed in first outside the support part 8
slightly inclined, so that both flaps reach the guide left and right at
the cable roller side; in doing so, the stopper must be adjacent
below outside the support part 8. Then push in the plug box 9 from
the outside passing the rims left and right of the plug funnel.
Fan 11 Remove both rubber buffers with pliers.
Electronic
7
Unlock the 3 catches and pull them through downward; in doing so,
take out the indications in the printed panel 2 because of the wire
lengths.