AEG SCB6181XLS, Руководство пользователя

Страница: 12 / 20

Problem Possible cause Solution
There is too much frost and
ice. The door is not closed cor-
rectly or the gasket is de-
formed/dirty. Refer to "Closing the door".
The water drainage plug is
not correctly positioned. Position the water drainage
plug in the correct way.
Food products are not
wrapped properly. Wrap the food products bet-
ter.
Temperature is set incor-
rectly. Refer to "Operation" .
The compressor does not
start immediately after
pressing the "FROSTMAT-
IC", or after changing the
temperature. This is normal, no error has
occurred. The compressor starts after a
period of time.
Water flows on the rear
plate of the refrigerator. During the automatic de-
frosting process, frost
melts on the rear plate. This is correct.
Water flows inside the refrig-
erator. Food products prevent the
water to flow into the wa-
ter collector. Make sure that food products
do not touch the rear plate.
The water outlet is clog-
ged. Clean the water outlet.
Water flows on the floor. The melting water outlet is
not connected to the
evaporative tray above the
compressor. Attach the melting water out-
let to the evaporative tray.
Temperature cannot be set. The "FROSTMATIC " is
switched on. Switch off "FROSTMATIC "
manually, or wait until the re-
sets automatically to set the
temperature. Refer to
"FROSTMATIC ".
The temperature in the ap-
pliance is too low/too high. The temperature regulator
is not set correctly. Set a higher/lower tempera-
ture.
The door is not closed cor-
rectly. Refer to "Closing the door".
The food products' tem-
perature is too high. Let the food products temper-
ature decrease to room tem-
perature before storage.
Many food products are
stored at the same time. Store less food products at the
same time.
www.aeg.com 12