AEG OKO-LAVAMAT 72330, Информация пользователя

Страница: 43 / 52

Setting up and connection instructions
43
Prepare the Installation Location
• The installation surface must be clean, dry and free of floor wax resi-
due and other lubricating coatings so that the unit does not slide
away. Do not use any lubricants as sliding aids.
• It is not recommended to set up the washing machine on deep-pile
carpets or on floor coverings with soft foam underlays, as this would
mean that the stability of the unit would not be guaranteed.
• Use ordinary rubber mats as underlays in locations with small-format
tiles.
• Never use wood, card or similar underlays to compensate for minor
floor unevenness. Always use the adjustable screw-type feet of the
machine.
• If, for reasons of space, it is not possible to avoid setting up the unit
next to a gas cooker or coal stove: Insert a thermally-insulating panel
between the washing machine and the cooker (85 x 57cm). This panel
must have an aluminium foil on the side against the cooker.
• The washing machine must not be set up in a room where there
is a danger of frost. Frost damage!
• The intake and drainage hoses must not be bent or pinched.
Setting Up on a Concrete Pedestal
When setting up the washing machine on
a concrete pedestal, it is essential for
safety reasons to fit stand plates in which
the washing machine is then adjusted.
The stand plates are available from the
Customer Service under spare part
number 645 425 058.
Setting Up on a Vibrating floor
In the case of vibrating floors, especially wooden beam floors with flex-
ible boards, securely screw a water-resistant wooden panel at least
15mm thick onto at least 2 of the floor beams. If possible, set up the
unit in a corner of the room where the wooden floor is best firmly
installed and is therefore least likely to be susceptible to vibrations.