37
Emergency emptying out
If the water is not discharged (pump is blocked, filter or drain hose are
clogged), proceed as follows to empty out the machine:
• pull out the plug from the power socket;
• close the water tap;
• if necessary, wait until the water has cooled;
• place a bowl on the floor;
• put the drain hose end into the bowl and let the water out.
Should it not be possible to have access to the drain hose because, for
example the appliance is built in the kitchen furniture, slightly loosen
the drain filter after placing a bowl on the floor to let the water come
out slowly.
At the end screw the filter again.
Frost precautions
If the machine is installed in a place where the temperature could drop
below 0°C, proceed as follows:
• Close the water tap and unscrew the water inlet hose from the tap.
• Place the end of the drain hose and the inlet hose in a bowl placed
on the floor.
• Select the “DRAIN” programme DESCARGA and run it until the
machine stops.
• Turn the programme selector dial to ANULACION (RESET).
• Press the ON/OFF button to switch the machine off.
• Remove the plug from the power socket.
• Screw the water inlet hose back on and put the drain hose back in its
place.
By doing this, any water remaining in the machine is removed, avoiding
ice forming and consequently damage to the appliance.
When you use the machine again, make sure that the ambient temper-
ature is above 0°C.
36
Cleaning and maintenance
Something not working?
If during the spin cycle the machine makes an unusual
whistling noise, different from the noise made by tradi-
tional washing machines, this is due to a new type of
motor.
If water is not visible in the drum, this is due to
the modern technology of new washing
machines that use less water than traditional
machines.
Troubleshooting
If a problem arises, you can try to solve it yourself following the
instructions below.
If you call out an engineer when one of the following problems arises,
or to repair a fault due to incorrect use, the call-out will be charged
even if requested within the guarantee period.
During machine operation the following alarm codes may be displayed:
-
E00:
problem with the water supply
-
E10:
problem with water draining
-
E20:
door open
Once the problem has been eliminated, press the START/PAUSE
but-
ton to restart the programme. If after all checks, the problem persists,
contact your local AEG Service Force Centre.
Problem
The machine does not work
Possible cause
The ON/OFF button
Depress the button.
has not been depressed.
The main electrical fuse
Replace the fuse.
has blown.
The door is not properly
Close the door; the click
closed
(E20)
.
of the lock should be heard.
The plug is not connected.
Insert the plug.
The START button has not
Press the button.
been pressed.
The DELAY START
Check the selected delay on
option has been selected.
the display.
Solution
