4.
Hold the door with one hand on each
side and pull it away from the
appliance at an upwards angle.
5.
Put the door with the outer side
down on a soft cloth on a stable
surface. This is to prevent scratches.
6.
Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
1
2
B
7.
Pull the door trim to the front to
remove it.
8.
Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
9.
Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, install
the glass panels and the door. Do the
above steps in the opposite sequence.
Install the smaller panel first, then the
larger.
10.6
Replacing the lamp
Put a cloth on the bottom of the interior
of the appliance. It prevents damage to
the lamp glass cover and the cavity.
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp.
The lamp and the lamp glass
cover can be hot.
1.
Deactivate the appliance.
2.
Remove the fuses from the fuse box
or deactivate the circuit breaker.
The top lamp
1.
Turn the lamp glass cover
counterclockwise to remove it.
2.
Clean the glass cover.
3.
Replace the lamp with a suitable 300
°C heat-resistant lamp.
4.
Install the glass cover.
11.
TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
11.1
What to do if...
Problem
Possible cause
Remedy
You cannot activate or oper-
ate the oven.
The oven is not connected
to an electrical supply or it is
connected incorrectly.
Check if the oven is correctly
connected to the electrical
supply (refer to the connec-
tion diagram if available).
The oven does not heat up.
The oven is deactivated.
Activate the oven.
ENGLISH
29
Содержание BP5013021
Страница 1: ...EN User Manual Oven BP5013021 BP501302W BP531302W BP531310W ...
Страница 34: ...www aeg com 34 ...
Страница 35: ...ENGLISH 35 ...
Страница 36: ...www aeg com shop 867316826 B 052016 ...