R3765/67G Series Network Analyzer Operation Manual
5.2 Transmission/Reflection Characteristic Measurement (Four Screen Display Mode)
5-10
5.2
Transmission/Reflection Characteristic Measurement (Four Screen Display
Mode)
5.2.1
Setup
Here explains how to measure all S parameters with four screen display.
S parameter measurement is possible only when CG type is used.
Four screen display is possible for either AG type or BG type.
•
880MHz band-pass filter is used as DUT.
Setup.
CG type
Figure 5-8 Setup of the Reflection Characteristic Measurement
Setup the R3765/67G series as follows.
First, preset by pressing [PRESET].
Note:
OPT11 or OPT14 uses a different [MEAS] menu.
For more information, refer to the description on page 7-10.
Block name
Setting
Key operation
ACTIVE
CHANNEL
Set the channel to 1.
[CH 1] (Initial
setup)
RESPONSE
Select the input port in the
receiver part.
Set the measurement
format to magnitude (log
display).
CG type
[MEAS]
{S11 REFL FWD}
(Initial setup)
[FORMAT
]
{LOG MAG}
(Initial setup)
STIMULUS
Center frequency
880MHz
Span frequency
100MHz
[CENTER]
[8]
[8]
[0]
[MHz]
[SPAN]
[1]
[0]
[0]
[MHz]
1
TEST PORT 2
TEST PORT 1
DUT
R3765CG/67CG
2
