R3765/67G Series Network Analyzer Operation Manual
3.2 Operation Keys
3-6
There are 3 methods for setting data.
Figure 3-5 How to Set Data
•
Ten-key and unit key
These keys are used to input numeric data.
Input a numeric value with ten-key, and press a unit key.
Pressing [BS] key deletes the rightmost digit of the numeric value which has been
input with ten-key.
•
Step key and data knob
Step key is used to set data by predefined step size.
Pressing [ ] key increments the data, while pressing [ ] key decrements the data.
Data knob is used to set data in units of predefined display resolution. It is very
convenient for finely adjusting set data.
•
Entry off key
Entry off key is operated by toggle.
Sets OFF the current entry data which is displayed in active area.
Press this key to avoid changing the entry data by actuating the knob by mistake.
Then, the marker can be moved by data knob.
Pressing the entry off key again can switch the entry OFF to ON.
But when the preset key is pressed or when the R3765/67G series is turned OFF
automatically, the entry off key cannot be switched to ON again.
If this function is selected before plotting, the screen cleaned the active area can be
plotted.
ENT
p
ENTRY
OFF
BS
GHz
7
8
9
MHz
4
5
6
kHz
1
2
3
X1
0
•
–
n
µ
Entry OFF key
Data knob
The continued change
is possible with display
resolution.
Ten key
Determines input
data by pressing unit
key.
Back space key
Unit key
Step key
Setting is possible
by step size.
