13
Chapter 2
2.4 LAN: Ethernet Connector
The UNO-2182 is equipped with a Realtek RTL8111B Ethernet LAN
controller that is fully compliant with IEEE 802.3u 10/100Mbps Ethernet
and also IEEE 802.3ab 1000Mbps Ethernet.. The Ethernet port provides a
standard RJ-45 jack on board, and LED indicators on the front side to
show its Link (Green : 1000 Mbps network, Orange : 100 Mbps network,
Blank : 10Mbps network.) and Active (Yellow LED) status.
2.5 Power Connector
The UNO-2182 comes with a Phoenix connector that carries 9 ~ 36 VDC
(ATX)
external power input, and features reversed wiring protection.
Therefore, it will not cause any damage to the system by reversed wiring
of ground line and power line. Please refer to Appendix A.6
2.6 PS/2 Keyboard and Mouse Connector
The UNO-2182 provides a PS/2 keyboard and PS/2 mouse connector. A
6-pin mini-DIN connector is located on the rear panel of the UNO-2182.
The UNO-2182 comes with an adapter to convert from the 6-pin mini-
DIN connector to two 6-pin mini-DIN connectors for PS/2 keyboard and
PS/2 mouse connection. Please refer to Appendix A.7 for its pin assign-
ments.
2.7 USB Connector
The USB connector is used for connecting any device that conforms to
the USB interface. Many recent digital devices conform to this standard.
The USB interface supports Plug and Play, which enables you to connect
or disconnect a device whenever you want, without turning off the com-
puter.
The UNO-2182 provides two connectors of USB interfaces, which gives
complete Plug & Play and hot swapping for up to 127 external devices.
The USB interface complies with USB EHCI, Rev. 2.0 compliant. The
USB interface can be disabled in the system BIOS setup. Please refer to
Appendix A.8 for its pin assignments.
