Advantech POC-S176 Series, Руководство пользователя

Страница: 20 / 58

POC-S176 User Manual 10
2.3 Running the BIOS Setup Program
Your POC-S176 has more than likely been properly set up and configured by your
dealer prior to delivery. You may still find it necessary to use the BIOS (Basic Input-
Output System) setup program to change system configuration information, such as
the current date and time or your type of hard drive. The setup program is stored in
read-only memory. It can be accessed either when you turn on or reset the panel PC,
by pressing the "Crtl+Alt+Del" key on your keyboard immediately after powering on
the computer.
The settings you specify with the setup program are recorded in a special area of
memory called CMOS RAM. This memory is backed up by a battery so that it will not
be erased when you turn off or reset the system. Whenever you turn on the power,
the system reads the settings stored in CMOS RAM and compares them to the
equipment check conducted during the power on self-test (POST). If an error occurs,
an error message will be displayed on screen, and you will be prompted to run the
setup program.
2.4 Installing System Software
Recent releases of operating systems from major vendors include setup programs
which load automatically and guide you through hard disk preparation and operating
system installation. The guidelines below will help you determine the steps necessary
to install your operating system on the panel PC hard drive.
If required, insert your operating system's installation or setup diskette into the exter-
nal diskette drive until the release button pops out.
The BIOS supports system boot-up directly from the CD-ROM drive. You may also
insert your system installation CD-ROM disk into your external CD-ROM drive.
Power on or reset the system by pressing the "Ctrl+Alt+Del" keys simultaneously.
The Point-of-Care Terminal will automatically load the operating system from the dis-
kette or CD-ROM.
If you are presented with the opening screen of a setup or installation program, follow
the instructions on screen. The setup program will guide you through preparation of
your hard drive, and installation of the operating system.
Note! Some distributors and system integrators may have already pre-
installed system software prior to shipment of your panel PC.