Advantech PCM-9377, Руководство пользователя

Страница: 43 / 128

29 Chapter 3
3.4.6 First/Second/Third/Other Boot Device
Select your boot device priority. Choices are: Floppy, LS120, HDD-0,
SCSI, CDROM, HDD-1, HDD-2, HDD-3, AIP100, LAN and disabled.
3.4.7 Swap Floppy Drive
If the system has two floppy drives, choose enable to assign physical
drive B to logical drive A and vice-versa. The commands are “enable” or
“disable”.
3.4.8 Boot up Floppy Seek
Enabled tests floppy drives to determine whether they have 40 or 80
tracks. The commands are “enable” or “disable”.
3.4.9 Boot Up NumLock Status
This feature selects the “power on” state for NumLock. The commands
are “Enabled” or “Disabled.”
3.4.10 Gate A20 Option
Normal: A pin in keyboard controller controls GateA20
Fast (Default): Chipest controls GateA20.
3.4.11 Typematic Rate Setting
The typematic rate is the rate key strokes repeat as determined by the key-
board controller. The commands are “Enabled” or “Disabled.” Enabling
allows the typematic rate and delay to be selected.
3.4.12 Typematic Rate (Chars/Sec)
BIOS accepts the following input values (characters/second) for type-
matic rate: 6, 8, 10, 12, 15, 20, 24, 30.
3.4.13 Typematic Delay (msec)
Typematic delay is the time interval between the appearance of two con-
secutive characters, when holding down a key. The input values for this
category are: 250, 500, 750, 1000 (msec).
3.4.14 Security Option
This setting determines whether the system will boot up if the
password is denied. Access to Setup is always limited.
System
The system will not boot, and access to Setup will be denied
if the correct password is not entered at the prompt.
Setup
The system will boot, but access to Setup will be denied if
the correct password is not entered at the prompt.