Advantech EKI-8500 Series, Руководство пользователя

Страница: 48 / 98

EKI-8500 Series User Manual 37
The following table describes the items in the previous figure.
4.3.1.5 Log Configuration
The System Log provides server mode operations. When the mode is enabled, a
syslog message is sent to the syslog server. The syslog protocol is based on UDP
communication and received on UDP port 514. The syslog server will not send
acknowledgments back sender since UDP is a connectionless protocol and it does
not provide acknowledgments. The syslog packet are sent out even if the syslog
server does not exist.
To configure System Log, access the page as follows:
1. Navigate to Configuration > System and click Log .
The System Log Configuration page displays.
Figure 4.10 System Log Configuration
The following table describes the items in the previous figure.
Item Description
Daylight Saving Time Click the drop-down menu to select disable (default), recurring, non-
recurring.

Disabled

Recurring: the configuration repeats every year

Non-Recurring: A single time configuration
Start Time Settings Enter the Month, Date, Year, Hours, and Minutes to setup start time.
End Time Settings Enter the Month, Date, Year, Hours, and Minutes to setup end time.
Offset Settings Enter the number of minutes to add during Daylight Saving Time
(Range: 1 to 1439).
Save Click Save to store the settings.
Reset Click Reset to clear the settings.
Item Description
Server Mode Click the drop-down menu to enable or disable (default) the server
mode function.
Server Address Enter the IPv4 host address of the syslog server. If DNS is featured, a
domain name can be indicated.
Syslog Level Click the drop-down menu to indicate the type of message:

Error: Send a specific message(s) if the severity code is less or
equal than Error (3).

Warning: Send a specific message(s) if the severity code is less
or equal than Warning (4).

Notice: Send a specific message(s) if the severity code is less or
equal than Notice (5).

Informational: Send a specific message(s) if the severity code is
less or equal than Informational (6).
Save Click Save to store the settings.
Reset Click Reset to clear the settings.