Advantech EKI-8500 Series, Руководство пользователя

Страница: 46 / 98

EKI-8500 Series User Manual 35
4.3.1.3 NTP Configuration
To configure NTP, access the page as follows:
1. Navigate to Configuration > System and click NTP .
The NTP Configuration page displays.
Figure 4.7 Configuring IP Settings
The following table describes the items in the previous figure.
4.3.1.4 Time Zone Configuration
To configure Time Zone Configuration, access the page as follows:
1. Navigate to Configuration > System and click Time .
Item Description
Delete Click Delete t o remove the specified route entry.
Network Enter the destination IP network or host address of the route. The
following values denotes a default route: 0.0.0.0 or IPv6 ::.
Mask Length Enter a value to define the IP network or host mask in number of bits
(prefix length). Valid values are between 0 and 32 bits (128 for IPv6
routes). Only a default route has a mask length of 0.
Gateway Enter the IP address of the IP gateway. The gateway and Network
must be of the same type.
Next Hop VLAN
(IPv6)
Enter the IPv6 to specify the interface associated with the gateway.
Range: 1 to 4094. The range is valid only when the corresponding
IPv6 interface is valid. Link-local addresses, must specify the next hop
VLAN. If the IPv6 gateway address is not link-local, the system
ignores the next hop VLAN for the gateway.
Distance Enter a value to specify the next hop distance for the route.
Add Route Click Add Route to add a route entry.
Item Description
Mode Click the drop-down menu to select the operation mode:

Enabled: Enable NTP client mode operation.

Disabled: Disable NTP client mode operation.
Server 1 / 5 Enter the IPv4 or IPv6 address of an NTP server. For IPv6 addresses,
enter a 128-bit record represented as eight fields of up to four
hexadecimal digits with a colon (:) separating each field.
Save Click Save to store the settings.
Reset Click Reset to clear the settings.