Advantech ACP-7000, Руководство пользователя

Страница: 18 / 52

ACP-7000 User Manual 8
2.2 Removing the Chassis Covers
Please refer to Figure 2.5 and proceed as follows.
1. Detach the two thumb screws on the upper edge of the rear panel.
2. Remove the top cover.
Figure 2.5 Removing the top chassis cover
2.3 Installing the Backplane
ACP-7000 supports backplanes with up to 20 slots. To install the backplane, please
refer to Figure 2.6 and proceed as follows:
1. Remove the top chassis cover, and then dismantle the hold-down clamp by
removing the four screws.
2. Put the backplane in the proper location and attach the supplied EMI spring
shielding with the screws provided. Then fasten it onto the chassis.
3. For the PICMG 1.0 BACKPLANE, connect the orange-white wire from connec-
tor “HCN1” on the backplane to connector “CN21” on the CPU card.
4. Connect the 20-pin ATX power connector from the power supply to the back-
plane. (For the PICMG 1.0 BACKPLANE, the 4-pin +12 V power connector is
connected to the CPU card.)
5. Replace the hold-down clamp and fasten it to the chassis.
6. Return the top chassis cover and fasten it.
Figure 2.6 Installing the backplane