Advantech-DLoG DLT-SA6100, Руководство пользователя

Страница: 22 / 27

Initial start-up
22 / 27 DLT-SA6100 Screen Blanking Solution, Manual V1.00
7.5.3. Sensor settings: Sensitivity configuration
The Sensitivity must be defined here so that DLT-SA6100 Screen Blanking Solution detects
whether or not the vehicle is in motion or stationary.
The sliding controller provides five setting levels: high / medium / low and two intermediate
values (between high & medium and between medium & low).
The following criteria determine which value should be set:
−
Condition and evenness of the ground on which the vehicle is moving.
−
Type of vehicle: different vibration strength of electric vehicles, petrol vehicles, etc.
−
Installation variant:
- Where is the vehicle mounted terminal fitted on the vehicle:
The vibrations vary depending on the mounting location (console, under the roof, etc.).
- What has been used to mount the vehicle mounted terminal to the vehicle:
The vibrations vary depending on the mounting type (long or short
RAM mounts, ADLoG mounting bracket, etc.).
The Sensitivity level that needs to be set for the vehicle mounted terminal depends on a wide
range of criteria and must be determined on a case by case basis.
NOTE
The following information on the Sensitivity setting can therefore be regarded as non-binding
recommendations.
High
If the vehicle is smooth running (e.g. electric vehicles) and the
ground is relatively level.
Mid High
Medium
Medium Low
Low
High
If the vehicle is vibrating heavily (e.g. petrol vehicles) and the
ground is uneven.
Mid High
Medium
Medium Low
Low