www.advancedco.com
39
www.advancedco.com
39
2. Press the number key that corresponds with the
line you want to configure. The example here is
LINE #1
. The window shows:
The Dialing Type determines which format the
D9068P uses for dialing on each telephone line.
Tone/Pulse attempts tone dialing first, and then
pulse dialing if tone dialing fails.
Monitor Line supervises phone line integrity.
If Wait Dialtone is set to
Yes
, the D9068P starts
dialing when it receives a dial tone. When the
Wait Dialtone is set to
No
, the D9068P waits 7
sec before dialing.
3. Press [1] to select
1: DIALING TYPE
. The
window shows:
4. Press the number key that corresponds with
your selection followed by [# Command]. Then
press [* Clear] to return to the Line Control
Submenu.
5. At the Line Control Submenu, press [2] for
2:
MONITOR LINE
. The window shows:
6. The current selection precedes the colon (:) on
the second line. Press the number key that
corresponds with your selection.
7. Press [# Command]. Then press [* Clear] to
return to the Line Control Submenu.
8. At the Line Control Submenu, press [3] to select
3: WAIT DIALTONE
. The window shows:
9. The current selection precedes the colon (:) on
the second line. Press the number key that
corresponds with your selection followed by [#
Command]. Then press [* Clear] to return to the
Line Control Submenu.
10. Use this same procedure to configure Line #2.
6: ACK WAIT TIME
To access
ACK WAIT TIME
, select
[0]: ROGRAM
--->
[5]: PROG ACC’NTS
--->
[6]: ACK WAIT TIME
.
After the D9068P dials the telephone number, it
waits for the receiver to answer the telephone and
send the proper handshake tones. If the
handshake is not detected, the D9068P hangs up.
This parameter sets the length of time the D9068P
waits before hanging up.
To set the amount of time the D9068P waits before
hanging up:
1. At the Prog Acc’nts Submenu, press [6] to select
6: ACK WAIT TIME
. The window shows:
2. Enter a value between 20 and 99 for the ACK
WAIT TIME and then press [# Command]. The
default value is 45 sec.
3. Press the [* Clear] key to return to the Prog
Acc’nts Submenu.
5.4.6 PROG
FORMATS
Use both telephone lines (enabled and
supervised) for UL installations.
PROG FORMATS
are used with 4/2 reporting,
4/2 reporting is not supported by the D9068P.