www.advancedco.com
37
www.advancedco.com
37
To program the system with phone numbers:
1. At the Prog Acc’nts Submenu, press [2] to select
PHONE NUMS
. The window shows:
2. Press the number key that corresponds with the
phone number you want to configure. In this
example, [1] was pressed to select
1: PHONE
#1
. The window shows:
3. Enter the telephone number and press [Drill] or
[Disable] to move between the digits.
4. Press [# Command] when the entry is complete.
Then, press [* Clear] to return to the Prog
Acc’nts Submenu.
You can include several special control codes in
the phone number by pressing [Test]. These
phone control codes are:
• * CODE: Press [Test] and then [1] for Touch
Tone “*” action.
• # CODE: Press [Test] and then [2] for Touch
Tone “#” action.
• /3 SEC DELAY: Press [Test] and then [3] for a
3-second delay.
3: PHONE CONTROL
To access
PHONE CONTROL
, select
[0]:
PROGRAM
--->
[5]: PROG ACC’NTS
--->
[3]:
PHONE CONTROL
.
The following information describes the features
associated with each telephone number.
To set telephone control:
1. At the Prog Acc’nts Submenu, press [3] to select
3: PHONE CONTROL
. The window shows:
2. Press the number key (1 or 2 for Phone Format)
that corresponds to the phone you want to
configure. In this example,
PHONE #1
is
selected. The window shows:
Before exiting the Phone Numbers
Programming Submenu, refer to the following
information on special control codes for
telephone numbers.
3: PHONE 1 TONE
and
4: PHONE 2 TONE
options are not used with the D9068P. These
tone settings are utilized in 4/2 format
communications, which are not supported by
the D9068P.
5: PHONE 1 TEXT
and
6: PHONE 2 TEXT
options are not used with the D9068P. Text
settings are utilized in Modem IIIa
2
format
communications, which is not supported by the
D9068P.
The D9068P supports two protocols: Contact
ID, and SIA 300.
1
: 4/2 REPORT,
2
: SIA 110,
RPRT
and
5: MODEM III
PHONE FORMAT(s)
are not supported by the D9068P.