Advanced Kiosks Aegis Booth Kiosk, Руководство пользователя

Страница: 9 / 27

Setup and usage
After the Aegis booth is installed at the chosen location there are a few items that should be
performed prior to use by the end user. This section will also mention the general usage of the
Aegis kiosk and its functionality.
Setting up the kiosk
The Aegis Booth is tested as a complete unit before leaving our manufacturing facility. The
booth is then disassembled and shipped to your location in pieces. Due to the nature of this
process, mishaps can occur in the assembly or damage could have been sustained during
shipping that would not be immediately apparent.
It is necessary to go over each item with the install team BEFORE they leave the location.
Verify power on the kiosk by plugging both outlets/plugs into a suitable AC outlet.
Connect to the internet using your chosen access type. (
NOTE . If you are using our
Zamok browser software, refer to the Zamok instructions on how to navigate our
software environment).
Observe that the climate control(fan) and lighting systems work as expected by pressing
the light and fan buttons on the control panel inside of the booth.
Observe that the smart glass and sanitation lights work by opening and closing the main
door with a person inside of the booth for one test and a person outside of the booth for
the other test.
Adjust audio output levels if desired from the windows control panel. (
NOTE. If you are
using our Zamok browser software, refer to the Zamok instructions on how to navigate
our software environment).
Adjust the pink/white noise generator to the volume that sounds good for your location’s
space.
Perform a test print on the included laser printer. (
NOTE . If you are using our Zamok
browser software, refer to the Zamok instructions on how to navigate our software
environment).
www.advancedkiosks.com | 8