OsmoTECH XT Single-Sample Micro-Osmometer Service Guide
53
Appendix E:
Regulatory notices
This product has been designed and manufactured to meet the intent of U.S., Canadian, and European regulatory
requirements as outlined below. Modifications made to this product that are not expressly approved in writing by the
manufacturer will void the user’s authority to operate this product, previously issued factory approvals, and the user’s
rights under the warranty.
The distributor or dealer may have applied additional local, national, or international approvals to this product. Consult the
distributor or dealer for more information and documentation.
Connections to this product must be made with industry-standard cables.
Symbol conventions
This symbol indicates conformity to relevant European directives.
This symbol indicates the product was tested to conform to relevant
Canadian and U.S. safety standards by Intertek Testing Services NA,
Inc. The ETL mark is approved in the United States as a Nationally
Recognized Testing Lab (NRTL) by OSHA, and in Canada by the
Standards Council of Canada.
This symbol indicates the product conforms to the Restriction of
Hazardous Substances Directive.
This symbol indicates the product conforms to the requirements of EU
Directive 2012/19/EU on “Waste Electrical and Electronic Equipment”
when disposed of in accordance with the provisions of
.
Regulatory Notices
Regulatory
approval type
Description
U.S. Safety
This product was listed by ETL testing laboratories as being in compliance with the requirements of UL 61010-1,
“Electrical Equipment for Laboratory Use; Part 1: General Requirements.” The “US” in the lower right of the ETL
mark demonstrates this listing.
Canadian Safety
This product was listed by ETL testing laboratories as being in compliance with the requirements of CAN/CSA
C22.2 No.61010-1, “Safety Requirements for Electrical Equipment for Measurement, Control and Laboratory Use;
General Requirements.” The “C” in the lower left of the ETL mark demonstrates this listing.
