Advanced Illumination Pulsar 320, Руководство оператора и инструкция по установке

Страница: 15 / 48

a d v a n c e d i l l u m i n a t i o n . c o m
P u l s a r 3 2 0 M a n u a l P u l s a r 3 2 0 M a n u a l
4.2 Pulsar 320 Controller Cable Connections
Four physical connections, one of which needs to be a USB or Ethernet will
be required to operate the Pulsar 320 and light head. Refer back to figure 1
for an illustration of the Pulsar 320’s front panel.
4.2.1 Power:
The input power connector is located near the bottom
center of the Pulsar 320’s front panel. The Pulsar 320 requires an external
24 volt supply for operation. The power supply needs to have sufficient
amperage rating to drive the light head in the desired mode of operation.
Advanced illumination recommends a minimum of 4A for full output
operation. A power cable is provided. The black wire is negative and the red
wire is positive. Plug the 2 pin connector into the socket labeled “INPUT”.
Observe the polarity markings on the right hand side of the connector
socket.
4.2.2 Trigger: The trigger input connectors are located at the upper right
of the Pulsar 320’s front panel. The differential trigger levels are CMOS/TTL
compatible but will accept input pulses as great as 30 V. Two input trigger
connectors are provided, one for each output. One trigger may be mapped
to both outputs. For more detailed triggering information refer to section
4.6 “External Trigger Interface”.
4.2.3 Ethernet: An RJ45 connector is located to the lower right of the
front panel and is provided for Ethernet connectivity. Standard protocols
supported are TCP/IP, UDP, TFTP via 10/100Base-T. For more detailed
information on Ethernet connectivity.
4.2.4 USB:
The USB connector is located to the right and center of the
front panel. A host computer will communicate with the Pulsar 320 via
this USB connection. Connect the provided USB cable between the USB
connection on the host computer and the connector labeled USB on the
Pulsar 320. The Pulsar 320 is Microsoft HID USB compliant. Therefore, a
host computer with Windows 2000, Windows XP or Windows Vista will
auto-detect the Pulsar 320.
Figure 6 is a connection diagram for the output connector. Connect light
head(s) in accordance with Figure 6.
4.2.5 Light Head:
Power to light heads is supplied by two independent
connectors on the front panel each having 5 pins. Table 1 identifies the
15