Advanced Energy AE 3TL 1000 Series, Инструкция по установке и эксплуатации

Страница: 44 / 126

• Phillips screws
• Tool for installing anchor bolts if mounting on a wall
To Mount the Inverter
1. Hold the wall mount bracket against the wall or framework where the inverter
will be mounted.
2. Use a pencil to draw a level, horizontal line approximately 40 cm (16″) above
the position intended for the display.
The inverter is designed only for vertical installation.
The following illustration shows the required dimensions and drilling locations
to attach the wall mount bracket to the wall.
M5 x 20 SS screw
M5 SS locking nut
See the following table for anchors
Wall
See the following table for anchors
Figure 4‑3. Wall mounting and bracket
3. Hold the wall mount bracket with the end with mounting hooks to the pencil
line. Verify that the wall mount bracket is level.
4. With the wall mount bracket in place, mark the screw holes with a pencil.
5. Remove the wall mount bracket.
6. Drill pilot holes.
7. Attach the wall mount bracket using the provided washers and screws.
Refer to Table 4-1 for specific information on wall structures and the
appropriate fasteners.
Advanced Energy
4‑8 Installing 570-1003552-05A