Managing the Shelf ID
326
Installation and Commissioning Manual
F
S
P
3000R
7 R
11
.1 8000
0015930
Issue
B
, ©
2012
ADVA AG Optical Netw
orking
ADVA Conf
idential
Setting Up the Shelf ID
The shelf display shows the shelf ID. The shelf ID must be set for each shelf.
This procedure describes how to set the shelf ID.
Procedure
Step 1
Press the lower or upper arrow buttons until the desired shelf ID num-
ber appears on the display. The ID number starts blinking.
You must press the Enter button for 5 seconds to verify your setting.
Otherwise, after 20 seconds the shelf ID number falls back to the prior
setting.
Step 2
Confirm the number by pressing the enter button for 5 seconds. After
5 seconds the verification starts and the display will show the follow-
ing:
valid
or
not valid
.
If the display indicates
valid
for two seconds, the verification was
successful. The display will then show the new shelf ID number.
If
not valid
is indicated for two seconds, the desired shelf ID num-
ber is already assigned to a shelf. The ID number falls back to the
prior one.
End of Procedure
Locking the Shelf ID in Service
After you have set up the shelf ID, it is recommended that you lock it in order to
prevent changing the ID by accident. This must be done for each shelf. To lock
the shelf ID proceed as follows:
Procedure
Step 1
Press the enter button for approx. 5 seconds. After 5 seconds the Ser-
vice Menu appears on the display.
Step 2
Use the lower arrow button to highlight the menu item Shelf ID.
Step 3
Press the enter button to open the Shelf ID submenu.
Step 4
Use the lower arrow button to move to the item Lock and press the
enter button to confirm.
Step 5
Use the upper arrow button to navigate to the angled arrow symbol at
the very top and press the enter button to return to the Service Menu.
Step 6
Press the enter button once more to save the setting and to close the
Service Menu. The display will indicate the set shelf ID number again.