ADTRAN TOTAL ACCESS 600R, Системное руководство

Страница: 52 / 196

Section 4 User Interface Guide Total Access 600R System Manual
52 © 2002 ADTRAN, Inc. 61200600L1-1A
S
YSTEM
C
ONFIG
> M
ANAGEMENT
> FDL M
ANAGEMENT
> A
CCEPT
A
LL
SNMP
When set to
O
N
, SNMP gets/sets received over the FDL link are always accepted regardless of the
community table. When set to
O
FF
,
the community table is searched for valid manager IP addresses and the
SNMP traffic is rejected if a match is not found. Default is
O
N
.
S
YSTEM
C
ONFIG
> S
YSLOG
Configure the unit Syslog client for use with a Syslog server (supplied with ADTRAN Utilities or available
on most Unix platforms) from this menu.
S
YSTEM
C
ONFIG
> S
YSLOG
> S
YSLOG
IP
IP address of the syslog daemon to which log message should be sent. The values must be dotted decimal
notation.
S
YSTEM
C
ONFIG
> S
YSLOG
> S
YSLOG
F
ORMAT
The
S
YSLOG FORMAT
is the format of log messages. "
A
DTRAN
" uses a format that is compatible with Adtran
Utilities and forces the Syslog Facility to LOCAL0.
U
NIX
uses the traditional Unix format and reports at the
configured facility level.
S
YSTEM
C
ONFIG
> S
YSLOG
> S
YSLOG
F
ACILITY
The choices are:
L
OCAL
0
,
L
OCAL
1
,
L
OCAL
2
,
L
OCAL
3
,
L
OCAL
4
,
L
OCAL
5
,
L
OCAL
6
,
L
OCAL
7
.
S
YSLOG
F
ACILITY
is the facility level for all messages forwarded from the unit to the syslog server. This allows all messages
received from the IAD to be filtered by facility level. See RFC3164: The BSD Syslog Protocol.
For additional information, reference RFC3164: The BSD Syslog Protocol.
Adtran Utilities may malfunction if messages are received in the Unix format.
This does not have to correspond to the facility level shown in the terminal mode option.
See SYSLOG using Terminal Mode on page 53.